# Epson Secure Printing: what it blocks and how to turn it off

**Symptom:** the app says *"Secure Printing is on. Turn it off on the printer, then try again."* Or a brand-new Epson is found on the network, the test page appears to send, and nothing comes out — no error, no light, and the printer's own status page says it's available. Panel self-tests print fine.

## Why it happens[​](#why-it-happens "Direct link to Why it happens")

Epson TM-series printers built for the EU and UK since **1 August 2025** ship with **Secure Printing** enabled, to meet the EU's Radio Equipment Directive. While it's on, the printer accepts jobs sent over the old unencrypted channels and then **silently discards** them.

| Channel                           | Secure Printing **on**   | **off** |
| --------------------------------- | ------------------------ | ------- |
| Raw TCP, port 9100                | Accepted, then discarded | Prints  |
| ePOS-Print over HTTP (80, 8008)   | Not served               | Prints  |
| ePOS-Print over HTTPS (443, 8043) | Prints                   | Prints  |

Units sold outside the EU can carry the same firmware. If a new Epson anywhere shows this symptom, check the setting.

## Turn it off[​](#turn-it-off "Direct link to Turn it off")

You need the printer's admin password. On recent models that's the **serial number** on the label underneath the printer; older models used `epson`.

1. Find the printer's address — it's on the status sheet (open the roll cover, hold **Feed**).
2. Open `https://printer-ip` in a browser and accept the certificate warning.
3. **Administrator Login**, then **Print → Secure Printing**.
4. Set it to **Disable** and confirm.
5. Unplug the printer for ten seconds and plug it back in.
6. Print the test page again.

A firmware update turns it back on

Epson resets the security configuration to its defaults on firmware update. If a printer that worked for months stops right after an update, repeat these steps.

While you're in there, set your own admin password — anyone on the same network can reach an open receipt printer.

## Still stuck?[​](#still-stuck "Direct link to Still stuck?")

Use **Copy setup report** and paste it into your message. See also [Epson's Radio Equipment Directive FAQ](https://www.epson.co.uk/en_GB/faq/KA-01896/contents?loc=en-us).

[Discord Community](https://wcpos.com/discord)<support@wcpos.com>
